Tell us about the job
Takes about a minute. No obligation.
Sizing a heat pump for Crenshaw County starts with what local conditions actually ask of the equipment, and the weather record here is a reasonable starting point for that conversation. 100 severe weather events were recorded in Crenshaw County, Alabama between 2015 and 2024. At roughly the national midpoint, that record describes a place where severe weather is real but not the defining pressure on a system. A contractor quoting an installation here will spend more time on load calculations, duct layout, and equipment match than on weather hardening. Get those right and the system runs well; get them wrong and the weather record provides no excuse.
Ductwork laid down for a furnace and window units carries assumptions about airflow that a heat pump does not share, and a house where that ductwork has never been touched will show those mismatches once a contractor pulls the registers and measures return capacity. Half the homes in Crenshaw County, Alabama were built in 1982 or earlier (2020-2024 ACS 5-year). That means the electrical panel gets checked too, since service sized for what builders specified then often falls short of what a heat pump draws now. The equipment a homeowner picks is only part of the quote; what runs behind the walls decides the rest of it.
What a Heat Pump Installation Covers
The outdoor unit sits on a pad beside the house and holds the compressor and the condenser coil, which are the components that do the heaviest work in the system. Inside, an air handler or indoor coil mounts in a utility space, an attic, or a closet and conditions the air before it moves through the home.
A refrigerant line set runs between the two units, connecting them through the wall or roofline. A thermostat mounts on an interior wall and gives the homeowner control over the whole system. Both pieces are part of what a contractor accounts for when doing a full installation.
The drawing shows a general layout of these components, and a licensed contractor determines exactly how each one applies to your house.
Get matched in Crenshaw CountyCrenshaw County, by the numbers
100 severe weather events were recorded in Crenshaw County, Alabama between 2015 and 2024.
NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.Half the homes in Crenshaw County, Alabama were built in 1982 or earlier (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesCrenshaw County, Alabama holds 6,583 housing units (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesOwners occupy 73.2% of the occupied homes in Crenshaw County, Alabama (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesRules & Standards Governing Heat Pump Installation in Crenshaw County, Alabama1 sourced rules and standards
Licensing Rules for HVAC Work in Crenshaw County, Alabama
Alabama requires state certification to do heating, air conditioning and refrigeration contracting: nobody may advertise, bid, pull permits or do the work unless the person in responsible charge is a certified contractor.
Severe Weather Events in Crenshaw County
Heat pump performance is shaped by what the climate demands of it, and local weather patterns are a workload fact, not background noise. How hard a system has to work, and how reliably it needs to hold up, is a local question that a contractor serving this area factors into every installation.
100 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.